1. palma integration of learning across subject discipline
1. 1. Emerging Technology in Networking, Visualization, Interfaces.
2.
3.
4.
5.
6.
7. Connecting the components 1 - Networked computer 2 - Network hub 3 - HP Jetdirect print server 4 - HP all-in-one
8. Step one: Connecting the components to the network Connect the all-in-one to the HP print server as shown below. If possible, do not place any routers, switches, or patch panels between the print server and the computer or the print server may not be detected. Step two: Installing the all-in-one software Install the all-in-one software following the steps below. Do not install the print server software. The networking software is included with the all-in-one installation software. There may be slight differences depending on the version of the all-in-one software and the Windows version. 1 . After connecting the components to the network, allow three to five minutes to pass. Then print a test page from the HP Jetdirect print server by pressing the Test button on the print server. This will verify that the connection between the print server and the all-in-one is working and will list the network information for the print server. Note the IP address on the second page. 2. Insert the all-in-one product CD into the CD-ROM drive. If the software does not start automatically, click Start , click Run , and then type :(D):etup.exe ( where "D" is the CD-ROM drive letter. Click OK to continue. 3. The software installation start menu will appear. Click the option to install the software. 4 . A Welcome screen may appear . Click Next to continue if a Welcome screen appears. 5. If a HP Software License Agreement screen appears, accept the agreement by clicking Yes to continue. 6. The setup type menu should appear, review the options available.