2. BOOLEAN INSTRUCTIONS CLR,CPL,SETB,AND,OR

3. BOOLEAN INSTRUCTIONS This group of instructions is associated with the single-bit operations of the 8051. This group allows manipulating the individual bits of bit addressable registers and memory locations as well as the CY flag. The P, OV, and AC flags cannot be directly altered. This group includes: Set, clear, and, or complement, move. Conditional jumps.

4. CLR <bit> CLR C CLR instruction can operate on the carry flag CLR C The CARRY flag is set to 0 CLR bit CLR instruction can operate on any directly addressable bit CLR P2.7 If Port 2 has been previously written with DCH (11011100), then the operation leaves the port set to 5CH (01011100)

5. SETB <bit> SETB C SETB instruction operates on the carry flag and sets the specified bit to 1 SETB C sets the carry flag to 1 SETB bit SETB instruction operates on any directly-addressable bit and sets the specified bit to 1 SETB P2.0 Port 2 has the value of 24H (00100100), the Port 2 value changes to 25H (00100101)

6. CPL <bit> CPL C This operation complements the carry flag CPL C CPL bit CPL instruction complements any directly addressable Bit CPL P2.2 If Port 2 has the value of 53H (01010011) then after the execution the port set to 55H (01010101)

7. ANL ANL C, <source-bit> This instruction ANDs the bit addressed with the carry bit and stores the result in the carry bit itself ANL C,P2.7 ;AND carry flag with bit 7 of P2 ANL C, /<source-bit> If a slash (/) is used in the source operand bit, the logical complement of the source bit is used, but the source bit itself is not affected ANL C,/OV ;AND with inverse of OV flag

8. ORL ORL C, <source-bit> This instruction ORs the bit addressed with the carry bit and stores the result in the carry bit itself ORL C,P2.5 ;OR carry flag with bit 5 of P2 ORL C, /<source-bit> If a slash (/) is used in the source operand bit, the logical complement of the source bit is used, but the source bit itself is not affected ORL C,/OV ;OR with inverse of OV flag

9. MOV <dest-bit>,<source-bit> One of the operands must be the carry flag; the other may be any directly-addressable bit MOV C,P3.3 MOV P2.0,C If P2=C5H (11000101), P3.3=0 and CY=1 initially, after instructions, P2=C4H (11000100) and CY=0

10. JC / JNC addr Jump to a relative address if CY is set / cleared.

11. JB / JNB <bit>,addr Jump to a relative address if a bit is set / cleared.

12. JBC <bit>,addr Jump to a relative address if a bit is set and clear the bit. JBC P1.3,ARRAY1 If P1=56H (01010110), the above instruction sequence will cause the program to branch to the instruction at ARRAY1, modifying P1 to 52H (01010010)