4. What can be known from
Psychrometric chart
โข If dry bulb and wet bulb temperatures are known, the
relative humidity can be read from the chart.
โข If the dry bulb and relative humidity are known, the wet
bulb temperature can be determined.
โข If wet bulb temperature and relative humidity are
known, the dry bulb temperature can be found.
5. What can be known from
Psychrometric chart
โข If wet bulb and dry bulb temperatures are known, the
dew point can be found.
โข If wet bulb and relative humidity are known, dew point
can be read from the chart.
โข If dry-bulb and relative humidity are known, dew point
can be found.
6. โข The quantity (kg) of moisture in air can be
determined from any of the following
combinations :
โ Dry bulb temperature and relative humidity ;
โ Dry bulb temperature and dew point ;
โ Wet bulb temperature and relative humidity ;
โ Wet bulb temperature and dew point temperature ;
โ Dry bulb temperature and wet bulb temperature ; and
โ Dew point temperature alone.
7. Tutorial โ 1
โข The atmospheric conditions are ; 20 ยฐC
and specific humidity of 0.0095 kg/kg of
dry air. Calculate the following :
โ Partial pressure of vapour
โ Relative humidity
8. โข Solution.
โ Dry bulb temperature, tdb = 20ยบC
โ Specific humidity, W = 0.0095 kg/kg of dry
air
Partial pressure of vapour, pv :
โข The specific humidity is given by
๐ =
0.622๐๐ฃ
๐๐ก โ ๐๐ฃ
9. Relative humidity ฯ :
โข Corresponding to 20ยบC, from steam tables,
pvs = 0.0234 bar
๐ =
๐๐ฃ
๐๐ฃ๐
10. Tutorial โ 2
โข The air supplied to a room of a building in
winter is to be at 17ยฐC and have a relative
humidity of 60%. If the barometric
pressure is 1.01325 bar, find :
โ The specific humidity (pvs = 0.0194 bar)
11. Tutorial โ 3
โข The sling psychrometer in a laboratory test recorded
the following readings : Dry bulb temperature = 35 ยฐC
Wet bulb temperature = 25 ยฐC.
โข Calculate the following :
โ Specific humidity
โ Relative humidity
โ Vapour density in air
โ Enthalpy of mixture per kg of dry air
โข Take atmospheric pressure = 1.0132 bar Dew point temperature โ
21.2 ยฐC; pvs = 0.0563
12. โข Vapour density :
From characteristic gas equation
pvVv = mvRvTv
pv = ฯvRvTv
Rv = (8314.3/18)
13. โข Enthalpy of mixture per kg of dry air, h :
h = cptdb + Whvapour
= 1.005 ร 35 + 0.01586 [hg + 1.88 (tdb โ tdp)]
= 35.175 + 0.01586 [2565.3 + 1.88 (35 โ 21.2)]
(where hg = 2565.3 kJ/kg corresponding to 35ยบC tdb)
= 76.27 kJ/kg of dry air.
14. Psychrometric Processes
โข In order to condition air to the conditions of
human comfort or of the optimum control of
an industrial process required, certain
processes are to be carried out on the outside
air available.
โข The processes affecting the psychrometric
properties of air are called psychrometric
processes
15. โข These processes involve
โ mixing of air streams,
โ heating,
โ cooling,
โ humidifying,
โ dehumidifying,
โ Adiabatic saturation and
โ mostly the combinations of these.
17. โข Mixing of several air streams is the process which
is very frequently used in air conditioning.
โข This mixing normally takes place without the
addition or rejection of either heat or moisture, i.e.,
adiabatically and at constant total moisture content.
content. Thus we can write the following equations :
18.
19. โข On the psychrometric chart, the specific humidity and
enthalpy scales are linear, ignoring enthalpy deviations.
โข Therefore, the final state 3 lies on a straight line
connecting the initial states of the two streams before
mixing, and the final state 3 divides this line into two
parts that are in the same ratio as were the two masses of
air before mixing.
20. Sensible Heating
โข When air passes over a dry surface which is at a temperature
greater than its (air) dry bulb temperature, it undergoes
sensible heating.
โข Thus the heating can be achieved by passing the air over
heating coil like electric resistance heating coils or steam coils.
โข During such a process, the specific humidity remains constant
but the dry bulb temperature rises and approaches that of the
surface. The extent to which it approaches the mean effective
surface temperature of the coil is conveniently expressed in
terms of the equivalent by-pass factor.
21. โข The by-pass factor (BF) for the process is
defined as the ratio of the difference
between the mean surface temperature of
the coil and leaving air temperature to the
difference between the mean surface
temperature and the entering air
temperature.
โข Thus, air at temperature tdb1, passes over a
heating coil with an average surface
temperature tdb3 and leaves at temperature
tdb2
22.
23. โข The value of the by-pass factor is a function of
coil design and velocity.
โข The heat added to the air can be obtained
directly from the entering and leaving
enthalpies (h2 โ h1) or it can be obtained
from the humid specific heat multiplied
by the temperature difference (tdb3โ tdb1)
24. Sensible Cooling
โข Air undergoes sensible cooling whenever it passes over
a surface that is at a temperature less than the dry bulb
temperature of the air but greater than the dew point
temperature.
โข Thus sensible cooling can be achieved by passing the
air over cooling coil like evaporating coil of the
refrigeration cycle or secondary brine coil.
โข During the process, the specific humidity remains
constant and dry bulb temperature decreases, approaching
the mean effective surface temperature.
25.
26. โข On a psychrometric chart the process will appear as a
horizonal line 1โ2, where point 3 represents the effective
surface temperature. For this process
BF = (tdb2โ tdb3)/(tdb1โ tdb3)
โข The heat removed from air can be obtained from the
enthalpy difference (h1 โ h2) or from humid specific heat
multiplied by the temperature difference (tdb1 โtdb2 ).
Hinweis der Redaktion
Pt = 1.0132
Pv = 0.01524 bar
0.65 or 65%
Dew point temperature (DPT). It is the temperature to which air must be cooled at
constant pressure in order to cause condensation of any of its water vapour. It is equal to steam
table saturation temperature corresponding to the actual partial pressure of water vapour in the
air