Here we are implementing a Master-Slave Communication between two Arduino Uno Board with HC-05(Bluetooth) and Sending orreceiving data to and from an MQTT Client.
2. What we are using in this project -
• Arduino UNO (2No)
•Ethernet shield
•HC-05(2No)
•LM-35 (Temp Sensor)
Project Description
Video Presentation
3. Arduino UNO (2No)
Ethernet shield
HC-05(2No)
LM-35 (Temp Sensor)
In the next slide, we will
give you a brief
introduction about them.
4. Arduino/Genuino Uno is a microcontroller board based on the ATmega328P
(datasheet). It has 14 digital input/output pins (of which 6 can be used as
PWM outputs), 6 analog inputs, a 16 MHz quartz crystal, a USB connection,
a power jack, an ICSP header and a reset button.
5. The Arduino Ethernet Shield 2 allows an Arduino Board to connect to the
Internet. It is based on the Wiznet W5500 Ethernet chip. The Wiznet W5500
provides a network (IP) stack capable of both TCP and UDP.
6. HC-05 module is an easy to use Bluetooth SPP (Serial Port Protocol)
module, designed for transparent wireless serial connection setup.
7. The LM35 series are precision integrated-circuit temperature devices with
an output voltage linearly-proportional to the Centigrade temperature.
8. Arduino Interface LM35 MQTT Using UART (2 HC-05 )(ARDUINO
UNO,ETHERNET SHIELD, LM35&Bluetooth)
You can check it's video at https://vimeo.com/196405731 and you can contact us at
info [@] deligence.com in case you have any query. You can also contact us at
sales [@] deligence.com in case of any Development requirement.
Here we are implementing a Master-Slave Communication between two Arduino
Uno Board with HC-05(Bluetooth) and Sending orreceiving data to and from an
MQTT Client.
Here we are using Ethernet Shield to Communicate with MQTT Broker Adafruit and
interface out Board with it. Here we are also using two additional libraries of
Adafruit (Link is given below).
Link: https://github.com/adafruit/Adafruit_MQTT_Library