For the regulated power supply circuit shown in Figure 6, assume regular diodes with 0.7V forward drop and a Zener diode with 0.7V forward drop, Vz=1OV at 20mA, I min=5mA and rz=10 ohm. Use a 15V (peak), 60Hz sine wave at the transformer secondary and assume a maximum ripple level of 1 V. (a) Compute the unknown components needed to design 10V DC supply. Refer Figure 6. Hint: find R first, and then C assuming a discharge path through R and the Zener, rz, (Load RL is disconnected). What is the ripple level for C22 muF? Sketch the rectified, filtered, and regulated outputs. Solution i have ssolved it on paper aand iam uploading them now http://i60.tinypic.com/oshml2.jpg http://i59.tinypic.com/zirih3.jpg http://i61.tinypic.com/2wqv595.jpg http://i57.tinypic.com/1zl8ah4.jpg .