7.11 It was stated in this chapter that the watchdog timer could be configured as an interval counter. Configure the MSP430 Watchdog Timer to toggle the red LED in the MSP430 Launchpad every three (3) seconds. To conserve energy the MSP43O needs to enter a low power mode after your configuration is complete.
Solution
/*
We can blink the RED LED for 3 seconds with code.
The basic logic I have here is, I\'ll just make the LED on and of every 250ms for 3 seconds
Connect a Red LED to the Pin 2.
*/
// This start when push the reset button:
void setup() {
// Setting the output.
pinMode(RED_LED, OUTPUT);
}
// This for loop runs for 3 seconds. i.e and LED keeps a loop of totall 250 + 250 ms = 500ms. This must loop for 500ms X 6 = 3000ms:
for(i=0;i<6;i++);
{
digitalWrite(RED_LED, HIGH); // Light on for 250ms
delay(250); // wait for a second
digitalWrite(RED_LED, LOW); // Light off for 250ms
delay(250); // wait for a second
}
// Now we introduce a program to make the MSP430 to sleep to maintain the device in low power mode:
{
if(i == 6)
{
digitalWrite(RED_LED, LOW); // turn off
}
.
7-11 It was stated in this chapter that the watchdog timer could be co.docx
1. 7.11 It was stated in this chapter that the watchdog timer could be configured as an interval
counter. Configure the MSP430 Watchdog Timer to toggle the red LED in the MSP430
Launchpad every three (3) seconds. To conserve energy the MSP43O needs to enter a low power
mode after your configuration is complete.
Solution
/*
We can blink the RED LED for 3 seconds with code.
The basic logic I have here is, I'll just make the LED on and of every 250ms for 3 seconds
Connect a Red LED to the Pin 2.
*/
// This start when push the reset button:
void setup() {
// Setting the output.
pinMode(RED_LED, OUTPUT);
}
// This for loop runs for 3 seconds. i.e and LED keeps a loop of totall 250 + 250 ms = 500ms.
This must loop for 500ms X 6 = 3000ms:
for(i=0;i<6;i++);
{
digitalWrite(RED_LED, HIGH); // Light on for 250ms
delay(250); // wait for a second
digitalWrite(RED_LED, LOW); // Light off for 250ms
delay(250); // wait for a second
}
// Now we introduce a program to make the MSP430 to sleep to maintain the device in low
power mode:
{
if(i == 6)
{
digitalWrite(RED_LED, LOW); // turn off
