Yaroslav Rozhankivskyy: Три складові і три передумови максимальної продуктивн...
Design and fabrication of hydraulic puller
1. ECWAY TECHNOLOGIES
IEEE PROJECTS & SOFTWARE DEVELOPMENTS
OUR OFFICES @ CHENNAI / TRICHY / KARUR / ERODE / MADURAI / SALEM / COIMBATORE
BANGALORE / HYDRABAD
CELL: +91 98949 17187, +91 875487 1111 / 2111 / 3111 / 4111 / 5111 / 6111 / 8111
VISIT: www.ecwaytechnologies.com | www.ecwayprojects.com
Mail to: ecwaytechnologies@gmail.com | ecwayembedded@gmail.com
DESIGN AND FABRICATION OF HYDRAULIC PULLER
OBJECTIVE
A hydraulic fluid power system is defined as a means of power transmission in
which relatively incompressible fluid is used as the power transmitting media. The
primary purpose of hydraulic system is the transfer of energy from one location to
another location and this energy into useful work.
Power clamping is used for holding the job as for as quickly and maintain the
constant pressure over the job. Here in our project PULLER is done by hydraulic
system. Power clamping system consists of movable jaw, fixed jaw, and hydraulic
circuit. This movable jaw is fixed with hydraulic cylinder. When pump is switched on
the hydraulic cylinder will moves forward and holds the object very tightly.
METHODOLOGY
The Hydraulic system pressure can be generated in the form of any physical
action which result a compression over the Hydraulic system or pneumatic pressure
which is developed in the form of air compressing externally can be applied to activate
2. Hydraulic system. There is a constant relation between pressure density, and volume,
According to Bernoulli ‘equations.
LINE DIAGRAM OF HYDRAULIC PULLER
3. MERITS:
It is a port type integrated hydraulic circuit.
The product has safely removed.
Need not required reservoir separately.
Manpower saved is the great advantage.
Time consumption is very less.
DEMERITS:
The leakage of the hydraulic fluid from the inlet valve during the transferring of
fluid from the cylinder to the reservoir after the process.
APPLICATIONS:
This puller is mainly used by electric motor service people and pump assemblers,
and two wheeler, four wheeler mechanics for removing the bearing from the shaft.
This device finds place in,
It is used almost in all types of industries (Large, small, medium scale industries).
This device is mainly used in AC Induction motor industries.
This device is suitable to hold job of any diameter (maximum job diameter of 25
mm to 70mm)