1. Overview
Sections are used to show interior details clearly.
A cutting-plane line shows where object was cut
Sectional Views to obtain the section view.
Cross hatching in the section view shows the
solid surface of the object which were cut through
to produce the section.
Section views may replace standard views.
Conventional practices, such as not showing
hatching on ribs and webs, help make sections
easier to interpret correctly.
Full Section Lines in Sectioning
Imagine the object cut through by the cutting plane.
Think of the two halves pulled apart and a view looking
on to the cut half.
Full Sections The Cutting Plane Line
The cutting plane line is a thick dark line which
uses one of the special patterns shown above.
The cutting plane line can be left out when it is
Full sections show the object cut in half
obvious where it must lie from the appearance
Cutting plane line can be left out because it of the section itself.
is understood to be through center
Usually replaces a standard view
1
1

2. Hatch Patterns Cutting Plane
Cutting Planes & Sections Lines in the Section View
show lines that may have been previously hidden, but are
now visible behind cutting plane
usually don’t show hidden lines in section-- section views
are to make interior details clear without hidden lines
show hidden lines only when the object would be
misinterpreted if they were not shown.
Some Rules for Hatching Dimension Values & Hatching
Adjacent areas divided by a visible line in a section
view never both contain hatching.
Hatching is never bounded by a hidden line.
Hatching should not run parallel or perpendicular to a
major feature.
Sectional views are often used to show interior
features clearly for dimensioning. If dimension values
or extension lines cross hatched areas, you should
break the hatching behind the dimension. The best
practice is to place dimensions outside the object
outline.
2
2

3. Half-Sections Broken-out Sections
Half-section
Removed Section
with break around a keyway
Removed Section Revolved Sections
Revolved sections are used to show the cross-
sectional shape of a bar, spoke, or arm in a single
view. The cross-section is taken perpendicular to the
view and then revolved 90 degrees around the center
axis.
3
3

4. More revolved Sections Revolved Sections
Examples of
Offset Sections
Revolved Sections
Three Offset Sections Do not hatch ribs & webs
When ribs, webs, and
other thin flat parts
are hatched, it gives a
false impression of
the object’s solidity.
Leave the hatching of
such features even
though the cutting
plane passes through
Notice the ends of the cutting plane labeled with letters and them.
the sections views neatly arranged and labeled to match.
4
4

5. Aligned Sections Examples of Aligned Sections
Aligned sections use
an angled cutting
plane to pass
through angled
features. The plane
and feature are then
imagined to be
revolved into the
original plane and
the section projected
from there
Revolve Symmetrical Features Conventional Breaks
Isometric Half-Sections
5
5