1. 1
Flow visualization
Objective: The main objective of this lab is, to enable the students to apply what they know
in theory and make them work in practice.
Theory
There are many different meters used in pipe flow: the turbine type meter, the Rota meter,
the orifices meter, the venture meter, the elbow meter and the nozzle meter are only a few
.each meter works by its ability to alter a certain physical characteristics of the flowing
fluid and allow this alteration to be measured. the measured alteration is the related to the
flow rate .a procedure of analyzing meters to determine their useful features is the subject
of this experiment .in our lab experiment we use the venture meter and the nozzle meter to
measure the flow rate of the flowing fluid .
Nozzle
In nozzle the flow causes a pressure loss between inlet and out let .this differential
pressure p is proportional to the flow .the nozzle type meters consists of totaling device
placed in to the flow. The totaling device creates a measurable difference from its upstream
to downstream side .the measured pressure difference is then related to the flow rate. like
venture meter, the pressure difference varies with flow rate .applying Bernoulli’s equation
to points 1 and 2 of the meter yields the same theoretical equation as that for the venture
meter. For any pressure difference, there will be two associated flow rates for these
meters: the theoretical flow rate and the actual flow rate (measured in the laboratory).the
ratio of actual to theoretical flow rate lead to the definition of a discharge coefficient (Cn).
V=αεAd√2⧍p/kp
K=132L/hmbar
Where (p in mbar)
Cn=k
2. 2
The venture meter
A fluid passing through smoothly varying constrictions experience changes in velocity and
pressure. These changes can be used to measure the flow rate of the fluid.
To calculate the flow rate of a fluid passing through a venture, enter the parameters below. (The
default calculation involves air passing through a medium-sized venture, with answers rounded
to 3 significant figures.)
3. 3
It contains a constriction known as the throat. when fluid flow through the
constriction ,it must experience an increase in velocity over the upstream value .the
velocity increase is accompanied by a decrease in static pressure at the throat .the
difference between upstream and throat static pressure is then measured and
relabeled to the flow rate .the greater the flow rate ,the greater the pressure drop
p.so the pressure difference( h=p/g) can be found as a function of the flow rate flow
rate obtained with equation above .for any h,it is possible to define a coefficient of
discharge CV as
Cv=QAC/QTH
For each and every measured actual flow rate through the venture meter, it is possible to
calculate a theoretical volume flow rate, Reynolds number, and a discharge coefficient .the
Reynolds number is given by
Re=V2D2/
4. 4
Where V2=the velocity at the throat of the meter
V2=QAC/A2
Using the hydrostatic equation applied to the air over liquid manometer, the pressure drop
and the head loss are related by:
(P1-p2)/ g=h
by combining the continuity equation,
Q=A1V1=A2V2
Where V=QTH
With Bernoulli equation
P1/ +v12/2= P2/+ v22/2
And substituting hydrostatic equation .it can be shown after simplification that the volume
flow rate through the venture meter is given by
QTH=A2gh/(1-(D24/D14))
The preceding equation represents the theoretical volume flow rate through the
venture meter. Notice that it was derived in the Bernoulli equation which does not
take frictional effect in to account .in the venture meter, there exists small pressure
loss due to viscous effects. thus for any pressure difference ,the actual flow rate will
be somewhat less than the theoretical value .the pressure in the venture is inversely
proportional to the velocity in the venture according to Bernoulli’s law equation .two
tapping’s allow measurement of the inlet pressure and the pressure are the smallest
area. this differential pressure
V=αεAd√2⧍p/kp
K=132L/hmbar
12. 12
0.06 0.08 0.1 0.12 0.14 0.16 0.18
0.01
0.02
0.03
0.04
0.05
0.06
0.07
0.08
Qth(L/s)
h(m)
Qth Vs h graph
Conclusion& discussion
In our first lab work on venture, we observe that, fluid's velocity must increase as it passes
through a constriction in accord with the principle of continuity, while its static pressure
must decrease in accord with the principle of conservation of mechanical energy. Thus any
gain in kinetic energy a fluid may accrue due to its increased velocity through a constriction
is balanced by a drop in pressure. This is reversed in nozzle meter, since the area of the
nozzle meter increases gradually, as fluid flow through it.
An equation for the drop in pressure due to the Venture effect may be derived from a
combination of Bernoulli's principle and the continuity equation.
13. 13
In our lab work, we observe that as the area of the meter decrease, the velocity of the fluid
which passes through the meter increases. This in turn increases the pressure drop (the
difference of pressure between the inlet and throat of the venture meter).
The theoretical volume flow rate is greater than the actual one; this is because when we
apply the Bernoulli equation, we did not consider the frictional loss inside the meter.
As both the actual and the theoretical flow rate decrease the coefficient of discharge also
decrease in venture meter. But in nozzle meter, generally, the coefficient of discharge
increases.