3. Evaporator Section:
Design will be prototyped in Sketch-Up.
Then these sections could be manufactured individually at cheap cost.
Cloth Section:
We will be using simple cotton cloth. (Non-dyed white)
4. Material Required Specification
1
Pebbles/Gravels Section:
(8-16 mm)
This layer is able to capture the bio-
impurities like algae from the water.
3
Fine Sand Section:
(125-250 um)
This layer purifies the water from the
physical impurities of smaller sizes.
5
Charcoal Layer:
This layer is inculcated to remove the
smell form the water along with some
chemical impurities.
2
Coarse Sand Section:
(1-2 mm)
This layer helps to eliminate physical
impurities of a particular size range.
4
Ceramic Layer:
This layer is manufactured by baking ceramic
clay with rice husk inside the dough.
Therefore, after heating, pores will be formed
in the layer. This pore helps to eliminate
impurities from the water
5. Maintenance Work
1) The purifier will be requiring maintenance scheduling in period of 6
months.
2) Manpower required for setup & maintenance is limited to two only.
10. Maintenance Work
1) Only replacement of waste paper bag from bottom container of toilet once in week.
2) Adding new bio-degradable paper bag along with synthetic powder
3) Need one man to fold/unfold structure in 30 mins.