In view of the numerous doubts and queries from you, concerning the compliance with Standards: EN 81-1:1998+A3:2009 and EN 81-2:1998+A3:2009, we have produced a diagram in order to explain the processes relating to our products.
This is an explanatory diagram that is constantly updated. As soon as there are any modifications in it, you will be informed by this same channel. We hope this information may be of use and help to you.
http://dynatech-elevation.com/pub/documentos/documentos_cuadro_UCM_v01_ingles_2abea81a.pdf
Unlocking the Power of ChatGPT and AI in Testing - A Real-World Look, present...
Diagram for the Implementation of the EN 81-1/2:1998+A3:2009 (UCM) Standards in our Products.
1. In the process to be
Per Unit
certified
The customer has a unit certified as
UCM and does not need to check the In the process to be
requirements requested in the A3 at certified
his/her installation
Governors
Safety Elements
Per Component
+
The customer makes the UCM
A3 Requirements: Safety gear
solutions according to his/her
Item 9.11 of EN81‐ needs; however he/she must +
1:1998+A3:2009 be held responsible for
checking that the unit meets Dynatech Steering
‐ car stop must be the A3 requirements in his/her Mechanisms
caused without
+
installation
exceeding 1.20 m
‐ ascending deceleration
of 1 g must not be
allowed and the values
accepted for the safety
gears must be allowed
in descending
deceleration Control System
Controller To be certified by the controller
Tornado + Dynatech
control System (CDC‐060
and BFS‐059)
Drive Machine
Tornado + Controller To be certified by the
operator