Lesson 01 - Hello, world!

1. Anypoint Lessons
#01 – Hello, World!

2. Step 01 – Create a new project

3. Step 02 – Insert the name of your project

4. Step 03 – This is your empty canvas. Let’s drag
a HTTP connector.

5. Step 04 – This is the connector and your
configurations.

6. Use the configurations as default.

7. Step 05 – Insert the SET Payload connector. This is
where you write your message (“Hello, world!”)

9. Step 06 – Insert a logger. This way you can
monitore your application on the console too.

11. Step 07 - Run your Project.

12. Step 08 – Execute your application on your
browser. Use the adress of the http connector
configuration.

13. You can see the result on your console too.

14. See you next time!