QUIZ#6- Dimensioning Practices than Directions Referring to the Robot Arm Part conceptual sketch below, use leaders to indicate at least 10 areas of the dimensioning practices that can be improved or updated. Refer to the Preferred Dimensioning Practices handouA to enumerate, circling reference and attaching to leader. As typical of take-home quizzes, it requires an individual effort. 3.0 302 DRILL EBTHRU 313 x 188 DR CBOR. HOLES) 1.50 THRU c2 45. CHAMFER. SHELL .25 2.00 d.25 25 R FILLETS .06R SCALE :2 Solution 1) error 1: the dimension 3.00 on the right side of the fig 2 is cancelled. 2) error 2: the dimension with dia 2.00 should be taken outside the figure 2. 3) error 3: the diameter of 2.25 in fig 1 is to be indicated with a leader line outside the figure. 4) error 4: the diameter of 1.30 in fig 1 is to be indicated with a leader line outside the figure. 5) error 5: sectional representation in figure 1 has a error. 6) error 6: there is no reference values for circle 3 (from outside to inside) of fig 1. 7) error 7: there is no reference value for circle 4(from outside to inside) of fig 1. 8) error 8: circle with dia 2.25 is not completely drawn 9) error 9: the diameter for one inner small circle is not shown for fig 1. 10) error 10: termination symbol for 1.25 in fig 2 is not shown properly..