Geol 370: Sedimentology and Stratigraphy Topic 17: Carbonate Depositional Systems

1. Photo by W. W. Little
Carbonate
Systems

2. Any questions?

3. Photo by W. W. Little
Carbonates are pretty

4. Photo by W. W. Little
Especially when covered by snow

5. Photo by W. W. Little
or carved by glacial processes

6. Photo by W. W. Little
Carbonate Factory
Carbonate sediment is formed mostly in place through biological
processes that are controlled by temperature, salinity, water depth,
basin geometry, and degree of clastic sediment influx.
“Carbonate sediments are born, not made.”

7. Modern Carbonate Settings
Modern carbonates are found in three major groups, warm-water, cool-
water, and pelagic. Each group is composed of a distinct set of
organisms and processes. Warm- and cool-water carbonates can occur
at similar latitudes on opposite sides of the same ocean basin due to
circulation patterns associated with the coriollis-effect.

8. Ancient Carbonate Settings
During periods of high eustatic sea-level, vast areas of continents
became flooded, leading to widespread development of shallow-water
carbonate systems. Pelagic carbonates did not develop until coccoliths
became abundant in the Cretaceous.

9. Sediment Production:
Foramol/bryomol Assemblage
Cool water carbonate sediment composed mostly of benthic forams,
molluscs, barnacles, bryazoa, and calcareous red algae.

10. Sediment Production:
Chlorozoan Assemblage
Warm water carbonate sediment composed of hermatypic corals and
calcareous green algae, in addition to foramol organisms.

11. Warm-water Carbonates
Warm-water carbonates form in shallow, tropical settings that support
photosynthetic-dependent organisms which rapidly produce calcitic
skeletal structures, such as corals and calcareous green and red algae.
Waters are commonly supersaturated with respect to calcium carbonate
that precipitates to form carbonate grains, including ooids, and lime mud.
Most reefs form in warm-water settings.

12. Modern Reef Occurrence
Carbonate reefs form primarily through organic processes that require
warm, shallow, clear water. These conditions are best met along the
margins of continents and islands located in a narrow band north and
south of the equator.

13. Cool-water Carbonates
Cool-water carbonates form in shallow to moderate-depth arctic,
temperate, and some tropical shelf settings that support non-photic
calcifying benthic invertebrates, such as molluscs, bryozoa, forams, and
barnacles, as well as photic calcareous red alage.

14. Pelagic Carbonates
Pelagic carbonate organisms, such as coccoliths and forams, exist in shallow photic
zones of the open ocean. Upon death, their skeletons settle to the seafloor and
accumulate to form intermediate-water carbonate oozes, mostly on shelves and ocean-
ridge flanks. Below the carbonate compensation depth (CCD), usually between 3000-
and 4000-m depth, cold water tends to be undersaturated with respect to calcium
carbonate leading to the dissolution, rather than accumulation of these tests.

15. Controlling Factors: Shelf Geometry
The development and lateral distribution of carbonate facies is
dependent, in part, on the width and shape of the shelf upon which
they form.
Belize shelf

16. Controlling Factors: Water Depth
Carbonate production occurs
primarily within the photic
zone, typically to maximum
depths of 80 to 100 m. Deep-
water carbonates can form to
depths of over 350 m. Water
depth strongly influences
both the physical processes at
work and the organisms
present in the carbonate
system.

17. Because carbonate platforms have flat tops and relatively steep slopes
and primary production is restricted to depths of around 50 m,
highstands allow a broader area to be productive than lowstands.
Water Depth and Geometry

18. Controlling Factors: Siliciclastic Influx
Carbonate systems tend to be poorly developed in regions of significant
siliciclastic input due to turbidity, which blocks sunlight and clogs
filter-feeding mechanisms.

19. Controlling Factors: Water
Temperature
Colder water can absorb more CO2 than warmer water, therefore, temperature
affects carbonate saturation potential, making it more likely for carbonate-secreting
organisms to exist in equatorial regions than in polar regions. However, some
carbonate-producing organisms do prefer cooler (below180
C) water conditions
Carbonate saturation levels
Warmer temperatures
increase chemical
reaction rates, leading
to a greater likelihood
of precipitation of
chemical grains.

20. Associated with ocean volume and, therefore, ionic concentrations,
glacial episodes favor formation of chemical grains and cement in the
form of aragonite and high-Mg calcite; whereas, interglacials tend
toward precipitation of calcite, which is more stable (weathers more
slowly) under subaerial conditions.
Controlling Factors: Water Chemistry

21. Controlling Factors: Sunlight
The vast majority of carbonate-producing organisms are phototropic
and/or photosynthetic or symbiotic with other organisms that are so
and, therefore, require shallow, clear water to thrive. Thus, carbonates
decrease poleward because of less winter sunlight and near clastic
sources because of turbidity.
Sunlight can penetrate
to around 100 m depth
but is most effective in
the upper 10 to 20
meter of the ocean.

22. Controlling Factors: Salinity
Salinity is a measure of the amount of dissolved solids contained within the water mass,
dominated in seawater by the cation Na+
and anion Cl-
. Most carbonate organisms
prefer salinites between 32 and 400
/00. Salinities too high kill most organisms, while
those too low lead to dissolution. Higher salinity enhances the production of chemical
grains.

23. Controlling Factors: Substrate
Different organisms prefer different types of substrates, depending upon
feeding habits, methods of locomotion, and needs for defense.

24. Organisms are often measured in terms of body size, diversity, and
total abundance. High energy environments tend to favor high
diversity and large body size; whereas, quiet water settings seem to
foster high abundance. Energy conditions impact water circulation,
which, in turn affects oxygenation.
Controlling Factors: Water Energy

25. Controlling Factors: Organic
Compounds (nutrients)
Coastal runoff and upwelling rich in organic nutrients favor production
of benthic and planktonic algae; whereas, reef-building organisms
prefer more clear waters.

26. The rate of carbonate production for shallow, warm-water reefs is rapid and can
usually outpace the rate of accommodation production through 3rd
-order cycles.
Glacio-eustatic rises and fault-related basin subsidence are among the few
exceptions. Uplift can place deeper water facies into shallower water settings.
Once accommodation space is filled (production reaches sea-level), it shuts off or
progrades leeward as sediment is washed off the platform top (highstand shedding).
Controlling Factors: Accommodation

27. The types of organisms forming organic build-ups have changed
through time.
Controlling Factors: Evolution
Cretaceous Rudist Reef Modern Coral Reef

28. Unlike clastics, grain size is not necessarily an indicator of energy
conditions. Rather, in carbonates, energy regime is demonstrated by
the amount of matrix that has or has not been winnowed from the
deposit.
Differences with Clastics: Grain Size
Low energy High energy

29. Carbonate Platforms
Carbonate platforms consist of thick accumulations of shallow water
carbonate sediment separated into a number of zones based on water
depth and energy conditions. As carbonates build to sea-level,
platform tops tend to be very flat.

30. Types of Carbonate Platforms
Carbonate platforms can be attached to or detached from the mainland
and may or may not have a rimmed margin isolating the main platform
from marine processes.

31. Ramp Model
Ramps are platforms that slope gently (<10
) basinward. Carbonate
sediment is produced by organisms or chemical processes. Some of
this material remains in place (in situ), and some is transported short
distances by waves, tides, and oceanic currents to produce a variety of
environments. Carbonate ramps are morpholigically similar to clastic
shoreface and barrier island systems.

35. Rimmed Platform Model
A rimmed platform has a reef or sand shoal near its outer (typically windward)
edge, which absorbs wave energy and creates a broad restricted zone of low
energy between the rim and the mainland or inner platform. Rimmed platforms
require a major break in slope to produce the necessary energy requirements.

36. Wilson Ramp Model

37. Detached Platform/Bank
Detached platforms, also called carbonate banks, are flat-topped
accumulations of carbonate sediment with steep slopes on both sides.

39. Great Bahama Bank
The Great Bahama Bank began forming in shallow, warm water during
the Jurassic over thinned continental crust as rifting began forming the
Atlantic Ocean. Carbonate sedimentation has continued to keep pace
with basin subsidence, forming a platform over 5-km thick that is
completely isolated from clastic influx.

40. Epeiric Platform
An epeiric platform is a shallow sea dominated by carbonate
sedimentation that covers a large portion of a craton. These have
been common and long-lived in the geologic past.

41. Reef Model
Reefs are commonly defined as topographic build-ups formed dominantly by the
growth of calcareous organisms. Reef systems are typically very-steep fronted rimmed
platforms composed of three major components from land to see, a shallow quiet water
lagoon, the reef itself (reef flat/top and reef front subfacies), which absorbs most of the
wave energy, and quiet deep water fore reef zone.

43. Fringing Reefs & Atolls
Reefs that form along the margins of an island are referred to as fringing reefs.
Fringing reefs that form around subsiding volcanic islands become atolls.

44. Reef Organisms

46. Tidal Model
Carbonate tidal systems are
relatively simple and
structurally similar to
clastic tidal systems,
dominated by fine-grained
sediment that is often
rippled, bioturbated, and
crossed by small channels.

47. Photo by W. W. Little
Laminated Mud
One of the most common facies in tidal, lagoonal, and deeper water
environments is laminated mud produced by tidal or wave
reworking of peloidal or bioclastic material. Calcareous algae is a
common source of carbonate mud.

48. Photo by W. W. Little
Ripple-bedded Mud
Ripple-bedded mud is formed by reworking of carbonate mud by tides
and waves and is common on tidal flats and lagoon floors.

49. Photo by W. W. Little
Structureless Mud
Structureless mud, composed mostly of peloidal and bioclastic material,
accumulates in quiet water settings.

50. Photo by W. W. Little
Bioturbated Mud
Bioturbation can be abundant, particularly on tidal flats and the floor of
lagoons.

51. Photo by W. W. Little

52. Photo by W. W. Little

53. Photo by W. W. Little

54. Thallasia/Hallimeda/Penicillus
Calcareous algae and grass are major
components of carbonate mud.

56. Photo by W. W. Little
Bioclastic Packstone
Bioclastic packstone commonly represents material broken from a reef
and can be found in lagoonal washover fans and as reef-front “talus”.

57. Photo by W. W. Little

58. Photo by W. W. Little
Oncoidal Packstones
Peloidal packstones form in relatively quiet-water zones that
occasionaly experience storm surges, such as lagoons or the
foreslope/deep ramp. Mud accumulates and algal binding takes place
during quiet water episodes. Oncoids are rolled over during storms.

59. Photo by W. W. Little
Intraclast Breccia (packstone)
Intraclast breccia is common in carbonates and has two common origins,
reworking during a lowering of base-level and diagenetic dissolution.

60. Photo by W. W. Little
Edgewise Conglomerate (packstone)
Edgewise conglomerate represents storm deposition. Grains are rip-up
clasts and can be imbricated.

61. Photo by W. W. Little
Bioclastic Grainstone
Bioclastic grainstone is common in high-energy zones, particularly
along wave-dominated shorelines. Grainstones can also be produced
by storms and are frequently cross-bedded.

63. Photo by W. W. Little

64. Photo by W. W. Little

65. Photo by W. W. Little

66. Photo by W. W. Little

67. Ooidal Grainstone
Ooidal Grainstones form in warm, high-energy shoreline settings. Ooids
are the most common form of coated grain.
Bahamas
oolite shoal

68. Organic Buildup/Boundstone
Organisms are the major source of sediment for carbonate systems.
Organic buildups have a framework of organisms, such as corals, that
bind other sediment together.

70. Photo by W. W. Little

71. Photo by W. W. Little

72. Photo by W. W. Little

73. Photo by W. W. Little

74. Photo by W. W. Little

75. Photo by W. W. Little

76. Photo by W. W. Little

77. Photo by W. W. Little
Algal Structures
Algal structures, such as stomatolites, ar common on tidal flats and in
shallow, subtidal environments.

78. Photo by W. W. Little

79. Photo by W. W. Little
Cherty Limestone/dolostone
Chert is a common diagenetic alteration component of both limestone
and dolostone.

80. Photo by W. W. Little

81. Great Barrier Reef,
Australia
Reef

82. Great Barrier Reef, Australia

83. Photo by W. W. Little
Barrier Reef, Lagoon, and Tidal Flat
Carbonate systems often include a reef, or other type of organic build-
up, that is detached and separated from the mainland by a lagoon. The
reef absorbs nearly all of the wave energy, while quiet water conditions
exist in the lagoon. Portions of the reef can be “washed over” into the
lagoon during storms. Tidal processes typically dominate the primary
shoreline landward of the lagoon.

85. Photo by W. W. Little

86. Shark Bay,
Australia
Tidal Flat

88. Idealized Vertical Profiles
Most carbonate successions shoal (coarsen)-upward from deeper, quiet-
water sediment to shoreline deposits.

89. Photo by W. W. Little
Large-scale Architecture
Carbonate sediment is produced primarily by organisms. Some of this
material remains in place (in situ), and some is transported short
distances by waves, tides, and oceanic currents to produce a variety of
carbonate environments.

90. A significant difference between carbonates and clastics is that facies
tend to build vertically, rather than laterally, as organisms strive to
maintain their relationship to base-level, producing thick, but often
narrow, facies belts.
Differences with Clastics: Facies Belts

92. Dolostones form primarily through diagenetic replacement of Ca in
limestones with Mg. The processes associated with dolomitization are
poorly understood, but four models have been proposed.
Dolomitization
Evaporite brine residue/seepage reflux model
Meteoric-marine/groundwater mixing model (obsolete)
Burial compaction/formation water model
Sea water/convection model