Diese Präsentation wurde erfolgreich gemeldet.
Die SlideShare-Präsentation wird heruntergeladen. ×

Presentation for ama conf mod

Anzeige
Anzeige
Anzeige
Anzeige
Anzeige
Anzeige
Anzeige
Anzeige
Anzeige
Anzeige
Anzeige
Anzeige
Wird geladen in …3
×

Hier ansehen

1 von 6 Anzeige
Anzeige

Weitere Verwandte Inhalte

Diashows für Sie (12)

Anzeige

Ähnlich wie Presentation for ama conf mod (20)

Presentation for ama conf mod

  1. 1. Preliminary Study of Indoor UWB Localization for At-Home Patient Monitoring<br />AMA-EMBS IEEE Conference<br />Washington D.C<br />March 22~23, 2010<br />Oregon State University <br />Oregon Health and Science University<br />
  2. 2. At-Home Patient tracking and Indoor localization<br /><ul><li> Purpose of this work
  3. 3. Monitor two patients’ movement simultaneously in home area
  4. 4. Expectations
  5. 5. Continuous medical service</li></ul> for at-home patients<br /><ul><li> Monitor patients’ safety effectively </li></ul> by nurses or doctors who are not <br /> in the same place with patients<br /><ul><li> Indoor localization
  6. 6. Conventional : RSSI, AOA, etc.
  7. 7. UWB TDOA technology has</li></ul> been employed for our system<br />Figure.1 Off-site staff can remotely monitor patients’ safety.<br />
  8. 8. UWB TDOA technology for indoor localization<br /><ul><li> Properties of UWB signal
  9. 9. Fine time resolution of UWB signal pulse width IR-UWB signal
  10. 10. Persistence of multiple reflection Robustness in indoor environment
  11. 11. Carrierless transmission  Hardware simplicity
  12. 12. Time Difference of Arrival(TDOA) technology
  13. 13. Define the hyperbola with foci at the location of receivers.</li></ul> TDOAR1,R2=(S2-S1)/c , where c is speed of light<br /><ul><li> Three receivers make one crossing point</li></ul> 3 is the minimum number of receivers for 2-D estimation<br /> and 4 receivers are needed for 3-D localization.<br />The most proper technique for <br />indoor localization and patient tracking system<br />
  14. 14. Fabricated UWB transceiver<br />2mm<br />1mm<br /><ul><li> IR-UWB Transceiver
  15. 15. 90nm-CMOS, 500Mbps, fully-integrated
  16. 16. Transmitter equalization (Plots in receiver)</li></ul>< Received signal without equalization><br />< Received signal with equalization><br />< 2mm2 IR-UWB Transceiver built in 90nm-CMOS ><br /> For our system, only transmitter has been used.<br /><ul><li> Frequency tunable transmitter
  17. 17. Two Tx’s have different frequency bands</li></ul> 3.1~4GHz and 4.1~5GHz for tracking two persons<br />< Transmitting Signal><br />
  18. 18. Experiment environment and results<br /><ul><li> Experiments
  19. 19. Point-of-Care lab at Oregon Health and Science University
  20. 20. Frequency division for 2 transmitters
  21. 21. 4 receivers connect to a sampling scope via cable(Receiver synchronized)
  22. 22. Computer processes the sampled data using Matlab
  23. 23. Results
  24. 24. The locations of two transmitters(patients) can be estimated </li></ul> simultaneously in every 1.3 ~ 1.5(s).<br /><ul><li> From 60 measurements, </li></ul>Unit : cm<br />
  25. 25. Discussion and Future works<br /><ul><li> System improvements
  26. 26. Higher accuracy than existing other system</li></ul> few tens of centimeter (even a few meter)-> less than 10cm error<br /><ul><li> low cost and easy-applicable form-factor</li></ul> low power consumption , 2mm2 chip in transceiver board<br /><ul><li> Entire system will be able to work wirelessly
  27. 27. Get rid of cables connecting receivers with a sampling scope </li></ul> Receiver synchronization issue has to be resolved <br /><ul><li> Estimation updating speed will be faster than wired system</li></ul> Sampling scope spend most of time to capture the signal and <br /> to transfer it to computer<br />Thank you!<br />

Hinweis der Redaktion

  • Hello, my name is SeungjinBaek. The topic of this presentation is “Preliminary study of indoor UWB localization for at-home patient monitoring. Our group is with Oregon State University and Oregon Health and Science University.

×