26. / م إعدادتوفيق أمير 25
CNCLatheManual(Mach3Controller) المخرطة ماكينة تشغيل كتيب
8.من للتاكدكارت سالمةInterface
Main _X LEDs Lamp
CLK if Flashing the Card Receive Signal form CPU to Run X-Axis motor
DIR indicate the Direction of motor
Main _Y LEDs Lamp
CLK if Flashing the Card Receive Signal form CPU to Run Tail Stock motor
DIR indicate the Direction of motor
OUT_Z LEDs Lamp
CLK if Flashing the Card Receive Signal form CPU to Run Z-Axis motor
DIR indicate the Direction of motor
Power LED Indicate to the Card Connected to the power Supply
Outputs LEDs
O3 Send Signal to Spindle motor Converter to run it
O4 indicate to the Card Send Signal to Pump Relay to switch on it
Power input 24
v
27. / م إعدادتوفيق أمير 26
CNCLatheManual(Mach3Controller) المخرطة ماكينة تشغيل كتيب
Inputs LEDs
I1 indicate to the tailStock Limit Switch is triggered
I2 indicate to the X-Axis Limit Switch is triggered
I3 indicate to the Z-Axis Limit Switch is triggered
I4 indicate to the Emergency Stop Button Was Pressed
I5 indicate to the Spindle Revelations
FAN & SPDLe LEDS indicate the Direction of Spindle
9.سالمة من للتاكدX & Z Driver
Power Input 24 V
GREEN LED indicate the Drive Was Connected to the Power Supply
RED LED will turn on once within each periodic time over-current protection will be activated when continuous current exceeds the limit or in
case of short circuit between motor coils or between motor coil and ground
RED LED will turn on twice within each periodic time when power supply voltage exceeds the limit, protection will be activated
RED LED will turn on four times within each periodic time Motor power lines wrong & not connected will activate this protection
LED will blink. When above protections are active, the motor shaft will be free Reset the drive by repowering it to make it
28. / م إعدادتوفيق أمير 27
CNCLatheManual(Mach3Controller) المخرطة ماكينة تشغيل كتيب
10.كارت سالمة من التأكدTailstock motor Driver
Power led indicate to the driver connected to the power supply (24 v)
RUN LED indicate to the Driver Receive Signal from Interface to Run
موتور لتحريك امر اعطtailstockمنmach3عن اسقبل االمر ان وتأكداحداثيات قراء طريقY-Axis
لمبة كانت اذاpowerولمبة مضيئةrunسليم الكارت ان معناه فهذا تومض