The ignition switch in your Volkswagen Jetta is used for controlling the electricity flow to several important components. When you are turning on the ignition key in the ignition system, the current is flowing from the battery to the starter solenoid through the wire. If the ignition switch is failed, your car doesn't start at all. Go through the slide to know the way to start the Volkswagen Jetta with a bad ignition switch.

1. How To Start Your
Volkswagen Jetta
With A Bad Ignition
Switch in
Woodinville?

2. To start the car, put
the key in the ignition
and turned it until you
hear the starter sound.

3. Ignition switch controls
the electricity flow to
the important
components in your
Volkswagen Jetta such
as:-
Battery
Starter
Ignition coils

4. When you turn on the
ignition key, the
current is flowing from
the battery to the
starter solenoid.

5. If you will notice
starting problems in
the car, then don’t
forget to check out the
ignition switch.

6. The following points
define the way to start
the Volkswagen Jetta
with a bad ignition
switch.

7. Jumper Cables

8. If the ignition switch is
failed, the jumper
cable is the easiest
method to start the
car.

9. First, open the hood to
determine the location
of the ignition coil and
the battery.

10. Then take a jumper
cable and connect its
positive side to the
terminal of the
battery.

11. In this way, the
dashboard of the car
gets enough power to
start the engine.

12. Hotwiring

13. In this method, locate
the steering wheel
column and remove
the plastic cover for
protecting the internal
parts.

14. Once it is removed,
locate the wiring
harness connector
among the several
cables and wires.

15. When it is located, the
next phase is to locate
the ignition, battery,
and starter
connectors.

16. In the last phase,
connect the ignition
on/off the wire to the
battery wire to start
the car.

17. Drill And
Screwdriver

18. Drill and screwdriver
methods are also used
for starting the car
with a bad ignition
switch.
In this process, you
have to locate the
keyhole and use a
metal drill for drilling
the keyhole.

19. Through this method,
the internal pins of the
ignition cylinder may
be damaged.

20. After that, put the
screwdriver into the
keyhole and turn on
the ignition for starting
the car.

21. Conclusion

22. When the ignition
switch of the
Volkswagen Jetta is
failed, fixing it is not an
easy task.

23. If your car is not
starting with the above
steps, take it to a
mechanic for
immediate repair.

24. WSC
https://woodinvillesportscars.com/
/woodinvillesportscars