1. “FOOT STEP POWER GENERATIONUSINGPIEZOELECTRICSENSOR &
AT89C52”
Submitted by:
Suyash Kesharwani (3352813032)
(ET&T), SSITM
Vonesh Nath (3352813044)
(ET&T), SSITM
Electronics & Telecommunication Engineering, 2016-17
Under the Guidence of :
Mr. Vishal Moyal
Associate Professor & HoD (ET&T), SSITM-SSTC
SSTC,SSITM

2. A Presentation
on
“FOOT STEP POWER GENERATION USING PIEZOELECTRIC SENSOR AND
AT89C52”
Submitted to
CHHATTISGARH SWAMI VIVEKANAND TECHNICAL UNIVERSITY
BHILAI, C.G.
In partial fulfillment
for the award of the Degree
Of
Bachelor of Engineering
In
ELECTRONICS & TELECOMMUNICATION ENGINEERING
By
Shri Shankaracharya Technical Campus
Shri Shankaracharya Institute of Technology& Management, Bhilai
Department of Electronics & Telecommunication Engineering
Junwani, P.O. Nehru Nagar. Bhilai – 490020 (C.G.), India
Session: 2015-2016
S no. Name Enrollment no. University Roll no.
1 Suyash Kesharwani AN3742 3352813032
2 Vonesh Nath AN3796 3352813044

3. POWER GENERATION THROUGH
FOOT STEPS

4. > For an alternative method to generate electricity there
are number of methods by which electricity can be
produced.
> Out of such methods, foot step energy generation can be
an effective method to generate electricity.
INTRODUCTION

5. NEED OF THE SYSTEM
The utilization of waste energy of foot power with
human motion is very important for highly populated
countries.
India and China where the roads, railway stations,
temples, etc. are all over crowded and millions of people
move around the clock.

6. BASIC PRINCIPLE
When a pedestrian steps on the top plate of the device,
the plate will dip down slightly.
The downward movement of the plate results in
rotation of the shaft of an electrical alternator fitted in the
device.

7. FOOT STEP
ARRANGEMENT PIEZO-ELECTRIC
MATERIAL
DC GENERATOR
BATTERYINVERTERLIGHT
LOAD
BLOCK DIAGRAM

8. FOOTSTEPARRANGEMENT

9. WORKING
The pushing power is converted into electricity
The piezoelectric material is fixed at the plane.
The spring is used to return the inclined step in same
position by releasing the load.
The shaft of generator is connected to the piezoelectric
material. DC is generated.

10.  To store the electricity in battery.
 Easy construction.
 Less number of parts required.
 Electricity can used for many purposes.
ADVANTAGES

11. DISADVANTAGES
Only applicable for the particular place.
Initial cost of this arrangement is high.
Tiles used are durable but not everlasting.

12.  In street light.
 In LED light for specific purposes.
 In air circulation system for room by the small fans.
 For used in security alarm.
 Also implement in DJ floor.
APPLICATION

13. > > We can use this principal in the speed breakers at high
ways , where the vehicles rush too much, thus increase input
torque and ultimate output of generator.
> > If we use this project at very busy stairs , then we
produce efficient useful electrical energy for large purposes
.
FUTURE ASPECTS

14. Expected Result & Discussion
Output power
Let,
Mass of pedestrian = 65 kg
Distance travelled by plate = 10 cm
So, work done on plate by impact
= weight of body * distance
= 65 * 9.81*0.1 Nm
= 63.765 J
So, power output
=work done/sec
=63.765/60 Watts
=1.06275 Watts
This much power is generated just by one foot step.

15. THANK YOU