The VT-330 Test Rack is a 3U OpenVPX rack with a 3-slot backplane, power supply and fan. The open frame design of the rack makes it ideally suited for software, firmware and hardware development of 3U VPX modules. Its main purpose is to provide a development platform for the OpenVPX hardware like the VF360. The 3-slot backplane has one payload slot and two peripheral slots with Fat Pipe (FP) connections between the payload slot and each peripheral slot. The VT-330 is available in both air-cooled and conduction cooled versions.

1. V T 3 3 0 3 U Te s t R a c k

2. VT-330 - VPX Test Platform
• Open Frame development system
• One System slot and two Payload
slots with Fat Pipe (FP) connections in
between
• 3 Rear Transition slots
• 200W power supply
• Sufficient for 3x VF360s boards
• + 3x RTM Modules
• Air cooled fan controller
• Adjustable
• Ideally suited for software,
firmware and hardware
development of 3U VPX modules.

3. VT-330 - VPX Test Platform
• Will hold 3x ‘Slim’ 3U OpenVPX boards
and RTM Modules (two shown)
• Will hold 2x ‘Fat’ 3U OpenVPX boards
when an extended height FMC Module
is attached to the front (not shown)
• Will hold 2x ‘Fat’ 3U OpenVPX boards
when an extended height RTM Module
is attached to the rear of the backplane
(not shown)

4. VT-330 - VPX Test Platform – Side View
• VF360 SBC to the right
• VR300 RTM to the left

5. VT-330 - VPX Test Platform – Side View
• VR300 RTM to the right
• VF360 to the left

6. VT-330 - VPX Test Platform – Rear View
• Rear of VT330
• Fitted with a ‘slim’ VR300 RTM
• Room for 3x ‘slim RTMs
• Room for 2x ‘fat’ RTMs
• 110VAC or 230VAC mains input
• Integrated PSU fan.

7. VT-330 - VPX Test Platform – Front View
• Front of VT330
• Fitted with a ‘slim’ VF360 3U board
• Room for 3x ‘slim 3U boards
• Room for 2x ‘fat’ 3U boards
• On/Off Switch
• Power rails indicators
• Fan Controller