The document summarizes details about a construction project to build an income tax complex in Rajbagh, Srinagar. It included 8 buildings on a 1375 sqm site with a total cost of 19 crores and completion date of 20/12/2017. The contractor was P.V. Techno Constt. Company and the architect was CP & DS Associates. It also provides information on pile foundations used, including different pile types, materials, uses, and details on pile construction methods for this specific project.
the ladakh protest in leh ladakh 2024 sonam wangchuk.pptx
Pile foundation power point ptesentation
1. ABOUT THE PROJECT:
The project was the construction of income tax complex at
rajbagh srinagar which included 8 building (Office building,type 3(A)
building,type 4-4 spl building,type 5&6 building ,Barrack,Guest houe,
A.T.M{post office}.The tender was awarded to the P.V Techno
Constt. Company, Ghaziabad.
Total Area of The Site =1375 sqm.
Total Cost of the Projet = 19 crores.
Time of completion =20/12/2017.
Name of the Contractor= P.V Techno Constt. Company, Ghaziabad.
Name of the architect and Design Consultant= CP & DS Assocites
Ghaziabad.
5. The pile foundation is used to describe a construction for the foundation
of a wall or a pier, which is supported on the pile.
Where it is placed …?
The piles may be placed separately or they may be placed in
the form of cluster throughout the length of the wall.
Where it is adopted …?
Piles are adopted when the loose soil extended to a great
depth.
The load of the structure is transmitted by the piles to hard
stratum below or it is resisted by the friction developed on the sided
of the piles.
6. The piles are applicable at the places where,
The load coming from the structure is very high & the
distribution of the load on soil is uneven.
The subsoil water level is likely to rise or fall appreciably.
The pumping of subsoil water is too costly for keeping the
foundation trench in dry condition.
The construction of raft foundation is likely to be very
expensive or it is likely to practically impossible.
The piles are considered to be long when their length exceeds 30
meters.
The structure is situated on sea shore or river bed and the
foundation is likely to adopted by the scouring action of water.
The piles are also used as anchors. They may be designed to give
lateral support or to resist an upward pressure of uplift pressure.
7. Soft toSoft to
Firm ClayFirm Clay
Large DistributedLarge Distributed
WeightWeight
Very Large ConcentratedVery Large Concentrated
WeightWeight
Strong RockStrong Rock
LowLow
WeightWeight
8. All the loads from the super structure like,
- Live loads
- Dead loads
- Wind loads
- Seismic load
The loads from the surrounding soil in case of seismic
event.
Water loads in case of off-shore structure.
9. The materials which are used in the construction of
piles are as follows :-
Timber piles
Steel piles
Concrete piles
11. I. Load bearing piles
II. Non-load bearing piles
I. Load bearing piles :-
It bear the load coming from the structure.
The Piles are generally driven vertically or in near vertical
position.
When a horizontal forces to be resisted, the inclined piles
may be driven in an inclined position and such inclined piles
are termed the batter piles
Load bearing piles are divided into,
i. Bearing piles
ii. Friction Piles
12. This piles penetrate to through the soft soil and
their bottoms rest on a hard bed. Thus, they are end
bearing piles and act as columns or piers.
The soft ground through which the piles pass also gives
some lateral support and this increases the load
carrying capacity of the bearing piles.
13. Transmit most ofTransmit most of
their loads to thetheir loads to the
load bearing layerload bearing layer
(dense sand or(dense sand or
rock). Most of therock). Most of the
pile capacity inferredpile capacity inferred
from the end bearingfrom the end bearing
point.point.
15. When loose soil extends to a great depth, the piles are
driven up to such a depth that the frictional resistance
developed at the sides of the piles equals the load
coming on the piles.
Great care should be taken to determine the frictional
resistance offered by the soil and suitable factor of
safety should be provided in the design.
16. Transmit most of theirTransmit most of their
load through the layersload through the layers
through which the pilesthrough which the piles
pass, i.e., mostlypass, i.e., mostly
through the surfacethrough the surface
friction with thefriction with the
surrounding soilssurrounding soils..
17. A) DETAILING OF PILE USED IN PROJECT:
The mixture of concrete for pcc is 1:5:10The mixture
of rcc concrete 1:4:8 A pile is basically a long cylinder
of a strong material such as concrete that is pushed
into the ground to act as a steady support for structure.
18. This piles are used to function as the separating members
below
ground level and they are generally not designed to take
any
vertical load.
This piles are also known as the sheet piles.
The materials used for the construction of non load bearing
piles are,
i. Timber sheet piles
ii. Steel sheet piles
iii.Concrete sheet piles
19. Non load bearing piles are used for the following purposes.
To isolate foundations from the adjacent soils. This
prevents escape of soil and passage of shocks and vibrations to
adjoining structure.
To prevent underground movement of water like to
construct a cofferdam, it requires a water tight enclosure in the
construction of foundation under water.
To prevent the transfer of machine vibrations to the
adjacent structures.
To construction of retaining wall.
To protect the river banks.
To retain the sides of foundation trenches.
20.
21. While we cast the piles we use tremie
method of concreting. In this method
the shaft of concrete pile is casted by using a
trimie pipe and concrete is poured with
pressure while the slurry and other raw
concrete or weak concrete comes up. In
order to get rid of weak concrete and to
achieve a uniform level piles are trimmed .
22. A pile cap is a thick concrete
mat that rests on concrete or
timber piles that have been
driven into soft or unstable
ground to provide a suitable
stable foundation.