Is Your BMW PDC Malfunctioning Discover How to Easily Reset It
Mazda Certified Pre-Owned CPO 150 Point Vehicle Inspection CardinaleWay Mazda in Mesa, AZ
1. Mazda Certified Pre-owned
150-Point Vehicle Inspection VIN ________________________
I. Manuals and Documentation 26. Confirm that vehicle does not pull Engine Coolant, Air Conditioning and
left or right upon braking Heating
Check that following items are located in 27. Check for unusual brake noise 60. Check for proper coolant specific
the glove compartment: 28. Confirm that brake pedal free play is gravity
within specifications 61. Pressure test cooling system to
1. Owner’s Manual 29. Confirm parking brake sets and fully check/correct leaks
2. Warranty Manual releases 62. Check/correct cooling fan operation
3. Vehicle History Report 30. Test for master cylinder bleed down 63. Check water pump for noise and
4. Perform emissions test and/or state 31. Confirm proper operation of brake leaks
inspection, if required booster 64. Confirm that coolant recovery tank
5. Verify that VIN plates match under is full to the correct level and does
Steering
hood, dash, and door pillar not leak
32. Test tilt steering wheel for proper
6. Check vehicle service history 65. Check hoses for cracks. Replace if
operation
33. Confirm that steering has smooth needed
II. Recalls feel in lock-to-lock range 66. Test A/C cooling operation
34. Check for excessive noise from 67. Confirm that A/C refrigerant sight
The following recalls were required and
power steering pump glass is clear
performed:
35. Confirm that steering wheel is 68. Check for any indication of leakage
7. None
centered in straight line driving at A/C connections
8. List recall numbers _____________ 69. Confirm normal heater operation
36. Confirm that vehicle tracks and
drives straight on level surface
III. Test Drive (10-15 Minutes) Battery (confirm the following)
37. Check for excessive tire vibration or
steering wheel shimmy 70. Battery is correct specification for
Engine:
38. Check for any unusual handling this vehicle
9. Confirm that engine is operating
conditions in cornering and braking 71. Battery is secured
properly and shows no obvious
39. Check for any wheel bearing noise 72. Battery posts are free of corrosion
signs of damage
40. Check for unusual tire noise 73. Cables are in good condition and
10. Check that engine oil pressure is
41. Listen for any other unusual noise, properly secured
within normal range
vibration, or harshness 74. Battery charge is at prescribed level
11. Check that engine reaches normal
operating temperature V. Raise Vehicle on Hoist
12. Confirm smooth idle speed & adjust Other test drive inspection points
if necessary 42. Confirm operation of cruise control Tires, Brakes & Suspension
13. Confirm smooth acceleration 43. Check for wind noise 75. Inspect tires for damage
14. Check for any unusual noise or 44. Check speedometer and tachometer 76. Confirm tires have minimum 5/32
vibration at idle and under for proper operation inch or 50% tread remaining
acceleration 45. Check for significant squeaks or 77. Set tires to proper inflation
15. Check for engine pinging rattles 78. All four tires must be of same brand,
46. Confirm that navigation system model, and size
Transmission works properly 79. Check wheels for damage or major
16. For manual transmission – check 47. Check for turn signal self-cancel scratches
clutch operation, smoothness, and operation 80. Check that spare tire is present and
slipping IV. Under the hood at proper inflation
17. For manual transmission – check for 81. Check that jack and tools are
synchronizer quality 48. Check for stored trouble codes present and functional
18. For automatic transmissions, check 49. Confirm that fuel cap is present and 82. Confirm that wheel covers and caps
shift quality & shift points the proper part are all present and secured
19. For automatic transmissions, check 50. Replace Air Filter if dirty or at service 83. Replace Disc brake pads if wear is
for slipping bands and clutches interval greater than 50%
20. Confirm operation of transmission 51. Replace Wiper Blades & top up 84. Replace Brake shoes if wear is
shift lock and key interlock system washer fluid greater than 50%
21. Confirm that transfer case switches 52. Check belts for cracks and wear 85. Inspect struts/shocks for leaks and
smoothly from 2WD to 4WD and 53. Check for engine oil leaks wear
back again 54. Check for any broken or missing 86. Inspect steering rack, linkage,
22. Confirm that there is no vibration ducts, brackets, and engine covers bushings, control arms, and dust
from CV joints and axles 55. Check for oil in the air cleaner boots
23. Confirm that there is no vibration 56. Check for water in the engine oil 87. Check tie rod ends, ball joints and
from drive shaft on rear drive 57. Test compression if engine shows other suspension links and bushings
vehicles any signs of excessive smoke, poor 88. Confirm that CV joint boots are free
performance or rough idle from damage
Brakes 58. Brake master cylinder and clutch
24. Check for excessive vibration during 89. Replace Engine Oil & Filter
master cylinder has the correct fluid
braking
level
25. Confirm that ABS operates on hard
59. Power Steering reservoir is at the
stops
correct level
(Rev. 7/08)
2. Mazda Certified Pre-owned
150-Point Vehicle Inspection VIN ________________________
Drive Train 123. License plate lights I certify that the above components and
90. Inspect transmission for leaks 124. Air bag light systems have been checked and are in
91. Check for any engine oil leaks from 125. Check engine light normal operating condition. I also certify
under the vehicle 126. Instrument panel lights that all outstanding recall work required on
92. Check for damage to drive and axle 127. A/C on indicator light this vehicle has been completed in
shafts 128. Dash light dimmer control accordance with Mazda’s requirements.
129. Rear window defroster indicator light
Frame & Underbody 130. Dome lights and interior courtesy
93. Check for frame or unibody damage lights
94. Check for rust
95. Check fuel tank and fuel lines for Vehicle Exterior (confirm the _____________________________________
damage or leaks following) Inspected by (Print technician’s name)
96. Inspect brake lines and hoses 131. No cracked or broken exterior
97. Check exhaust system and rubber lenses
hangers 132. All emblems are present and in good
98. Check for presence of catalytic condition ____________________________________
converter and shielding 133. Outside rearview mirrors function Technician’s signature
99. Inspect motor mounts and and no damage to lenses
transmission mounts 134. Windshield is free of cracks, large
chips, and improper repairs ____________________________________
135. Body is free of major dings Dealership Name/Number
VI. Lower Vehicle
136. Bumpers are free of cuts and
Body Electronics (confirm the scratches
following) ____________________________________
137. Paint is free of major scratches and
100. Horns function Date
chips
101. Clock is operational 138. No evidence of mismatched paint
102. Ambient temperature displays if 139. Truck bed liner is in good condition
equipped 140. Tailgate, hood, and trunk latches
103. Steering wheel controls are and hydraulic stays function properly
operational 141. Convertible top functions correctly
104. All wiper speeds work correctly 142. Roof rack is secure and in good
105. Windshield washer operates condition
106. Cigarette lighter and power outlets 143. All aftermarket accessories are
are operational tested
107. Power windows operate from master 144. Inappropriate aftermarket
switch and all door switches accessories are removed
108. Door locks operate from the master
switch and with the remote if Vehicle Interior (Inspect the
equipped following)
109. Operation of child rear door locks. 145. Cup holders, ashtrays, and storage
Set to unlock position compartments are present and clean
110. Power sunroof operates properly 146. Seats, carpets, floor mats, door
111. Radio, CD, cassette, and speakers panels, and headliner are free of
operate stains and abnormal wear
112. Alarm system is functional 147. Seats and headrests work properly
113. Keyless remote entry is present and in all positions
completely functional 148. Seatbelts have full range of
114. Rear defogger grid lines do not extension and smooth operation.
show any damage No stains or wear
149. Seatbelts lock up per specification
Interior/Exterior Lighting (confirm that 150. Remote hood and fuel door releases
all are functional) operate normally
115. Low beam and high beam
headlights
116. Check headlight aim
117. High beam indicator light
118. Turn signal lights and hazard lights
119. Taillights and brake lights
120. Fog lamps
121. Side marker lights
122. Backup lights
(Rev. 7/08)