4. Lab 7A Schematic Symbols
NOTE: When entering ground, make sure you give it the name 0 or
you will receive and error message when you run the simulation.
31 July 2003 ELEC 101 Lab 7 4
13. To Configure RVAL
• DCL on Parameters
• CL on New Column
• From the Dialog Box specify the Name and Value
as shown in the following graphic
• CL on Apply
31 July 2003 ELEC 101 Lab 7 13
16. To Configure RVAL
• The RVAL column was created and selected as
shown in the previous graphic. The exact location
of the new column may be in a different position.
• CL on the Display Button
• CL on the Name and Value Button as shown in the
next graphic
• Close the window
31 July 2003 ELEC 101 Lab 7 16
18. LAB 07C - Create a DC Sweep
• Create a New Simulation Profile called lab07c
• Create the same DC Sweep as used for lab07a
• CL and place a check in Parametric Sweep
• CL in the Global Parameter Option button
• Enter the Parameter name: RVAL
• CL in the Value List Option button
• In the Value List enter the space delimited values
100 200 300 (there is only one space between the
three values)
• CL on OK
31 July 2003 ELEC 101 Lab 7 18
20. Lab 7C Output Available Sections
Leave all the list values are selected
If you wanted to select one or more of the profiles, Hold
CTRL and CL to select or deselect a specific multiple
profiles
31 July 2003 ELEC 101 Lab 7 20