Good Stuff Happens in 1:1 Meetings: Why you need them and how to do them well
Installing a car alarm system in simple easy to do steps
1. Installing a Car Alarm System in Simple Easy To Do Steps
Installing the alarm system in your car is a complex process, especially if you have never done it
before. Nevertheless, considering that a number of alarm systems these days come with easy to
install options as well as a detailed installation guide, you can undertake the installation on your
own easily. However, if you are not used to handling tools, do not take a chance with your
expensive car and choose an efficient San Francisco car alarm install center to have the alarm
system installed. For car music system, you can choose a South San Francisco car stereo
installation center. Here are easy steps that can help you with car alarm installation. iPod car
installation and Burlingame car navigator system can also be installed with ease.
Understand your car and assimilate required tools
To begin with, understand the way your car has been built. The easiest way is to obtain diagrams
of the car’s layout so that you can check out the wiring system. This is important because every
car comes with slightly different wiring system. Although the user manual is useful, to have a
precise idea about the wiring of your car is helpful. Secondly, get the required tools.
Screwdrivers, cutting pliers, screws and a drill are adequate. This is common for installation of
Burlingame car navigator and iPod car installation.
Mounting the siren
For mounting the siren, find the mounting area, which is usually below the hood of your car or in
the inner fender. You will have to undo the panels covering it in order to place the siren out of
sight. The siren should not be close to heat sources such as heater cores, radiators and exhausts.
Maintain a distance of at least one and a half feet between the heat source and exhaust. The
speaker of the siren should face downwards in order to protect it from water damage. The surface
behind the chosen spot should not contain wiring because you need to drill screws into it which
might cause damage to the wiring. The siren can be mounted with nuts, bolts and screws.
Fix the wiring
The next step is to drill into the rubber firewall so that the wire of the siren can be passed through
the hole to the back seat. The power line of the alarm system should be close to the battery. A
fuse wire needs to be attached. Using screws, nuts and bolts, the control module should be
mounted under the steering column below the dashboard.
Fix the LED display
You can drill into the dashboard to fix the LED screen. The wiring will also pass through the
hole to connect the screen. A mounting tape can be used to secure the LED indicator.
Secure indicators
2. Identify the wires that are connected to door lighting and power locking system. A sensor should
be connected to these wires. All input and output wires should be attached to the alarm module.
Finishing
You will find a lot of wire in the car. Just bundle them and secure them under the dashboard.
Finally, connect the power input wire to the car battery.
Author’s bio: South San Francisco car stereo and San Francisco car alarm install centers
can be helpful in installing car accessories. A good store to buy your car accessories is
http://www.motormusiccarstereo.com/. You can purchase high quality accessories such as
Burlingame car navigator and iPod car installation kit from the store.