Good Stuff Happens in 1:1 Meetings: Why you need them and how to do them well
Tattoo machine startup reason
1. Tattoo machine startup reason
Tattoo machine work decides whether easy? --- world tattoo machine, the style is not one, but
works very much the same. There is a world of difference of work performance, needle, needle
wave frequency is not the same, the length of working time is not a
,... Fault solution
1, elastic rod had oblique spring contacts, the elastic rod screw loosening the stretch rod spin
down the encounter, contacts, and then rotate the right position, tighten the screw locking elastic
rod.
2, the power switch is not open, the tattoo power supply is switched on, turn on the power
switch, indicator light red
In 3, the regulating button (VOLTAGE) in the zero position, while the V table pointer in the zero
position, the adjusting button clockwise rotates slowly, while V table pointer also in revolving, V
table pointer should stop in 6-10V.
In 4, before the spring contact elastic rod touch, touch too tight, can not start, is more likely to
produce short circuit, playing the power switch, indicating lamp is bright green with no voltage
will stretch rod screw loosening, the elastic rod to come loose from the shrapnel contact reset
elastic rod contacted with the contacts, the restart of the power supply, adjust the elastic rod to
the appropriate position.
5, work stopped: often work carelessly, also don't know when to pull the pulling power line,
leaving the joint position.
Check foot switch, power line plug is in place
In 6, after work, cleaning and disinfecting tattoo machine, the machine on the wires out (CDH),
check the tattoo machine head have the dislocation (broken), for electrical, wire welding
7, open the power jump indicating lamp is bright green, check the power line plug and a pedal
switch plug, if broken, broken may touch line (short cut), broken head, must use the soldering
iron, OK!