http://www.patdolanplumbing.com/service-areas/massapequa-plumber/ Water heaters are typically sealed and lined with a protective surface and may be difficult to repair on your own.

1. Why does my water heater leak from the top?
Water heater leaks may be caused by a variety of
issues. If a water heater leaks from the top, it may be
caused by too much pressure as a result of a
defective thermostat. Relieving pressure from the
valve may help in stopping the leak and can be
accomplished by opening and closing the valve a few
times. Whenever you open the valve but you have
difficulty closing it, replacing the valve may be
necessary. But before you run to your nearest
hardware store, it’s important to check the root
cause of the leak. If you have doubts, it is
recommended to call a professional plumber to fix it
for you.
Water heaters are typically sealed and lined with a protective surface and may
be difficult to repair on your own. If the leak comes from the tank itself, it may
not be repairable and needs to be replaced instead. Determine first the source
of the leak and if it comes from any pipes or fittings attached, there’s a good
chance that it can be repaired and fixed.
A leaking water heater should not be ignored because it can cause thousands
of dollars’ worth of damage. The first signs of water damage start with a few
drops here and there but take it as a serious sign of a bigger problem. A
damaged pipe or a leaking water heater can damage your furniture, cause
water stains on the floor and ceilings, and can also lead to other issues like
molds and rotten surfaces.

2. Should you uncover a leak, don’t delay corrective action and call a
professional plumber (Plumber 11758) to fix it for you. But before the plumber
arrives, here are some steps that you need to take to make sure that further
damage will be prevented.
1. Shut down the power source if you’re using an
electric water heater. Make sure to turn the power
off directly at the circuit breaker.
2. If you’re using a gas heater, turn off the gas valve.
3. Shut the cold water supply off by closing the valve
that goes into the water heater.
4. Release the pressure in the tank and completely
drain the water out the water heater.
5. Check if you can remove the overflow pipe without
the need to cut it off. If it’s glued or soldered onto the
heater, wait for the plumber to arrive.
Implementing these simple strategies before your local plumber arives will
help prevent a potential costly incident.
For further Information please visit http://www.patdolanplumbing.com/service-areas/massapequa-plumber/
Massapequa Plumber
Plumber Massapequa
Plumber 11758