The CleanAir MET-80 is the leading solution for continuous mercury monitoring in the U.S. Developed in 2004 for the now-defuct Clean Air Mercury Rule, the MET-80 has continued to evolve over the years and is in its fourth generation. It is poised to tackle the Utility MATS and Portland Cement MACT mercury monitoring requirements.

1. Why CleanAir’s MET-80 is the BEST
SOLUTION for mercury monitoring
under MATS.

2. So, MATS requires utilities to
monitor mercury 24/7/365

3. Unless you have an extension,
MATS compliance starts
April 16, 2014

4. THAT’S LESS THAN
8 MONTHS AWAY

5. It feels like we’ve been here before…

6. Remember CAMR?

7. Utilities spent
$millions on mercury
CEMS hardware as
they prepared for
CAMR

8. A lot of it didn’t work…

9. or it cost a fortune to operate…

10. OR BOTH!

11. Lucky for
them, most
plants didn’t
need it…
The rule was vacated
by the courts in 2008

12. Recognizing the deficiency in Hg
CEMS, a few plants went with
sorbent trap systems instead

13. They had their reasons

14.  Cheaper than CEMS
 Back-up for CEMS
 More sensitivity than CEMS
 More reliable than CEMS
 Simpler than CEMS

15. CleanAir created the MET-80 in 2004
to address these customers’ needs

16. Before the MET-80, sorbent trap
systems (aka Appendix K Samplers)
were essentially re-purposed stack
testing equipment

17. Before the MET-80, sorbent trap
systems (aka Appendix K Samplers)
were essentially re-purposed stack
testing equipment
They were viewed as back-ups to the primary
CEMS, not known for their long-term reliability

18. They They were viewed were as kind back-of ups cheap
to the primary
CEMS, not known for their long-term reliability

19. They They were viewed were as kind back-of ups cheap
to the primary
CEMS, not known for their long-term reliability
And they were giving the technology a bad reputation

20. We designed the
MET-80 from the
ground up to be
the Primary
Mercury
Monitoring
System

21. And we had a philosophy…

22. MET-80 DESIGN PHILOSOPHY
It would be reliable

23. MET-80 DESIGN PHILOSOPHY
It would be reliable
> 95% availability

24. MET-80 DESIGN PHILOSOPHY
It would be robust

25. MET-80 DESIGN PHILOSOPHY
It would be robust
Able to handle the worst stack and
weather conditions out there,
24/7/365

26. MET-80 DESIGN PHILOSOPHY
It would be simple

27. MET-80 DESIGN PHILOSOPHY
It would be simple
A technician could operate and
maintain it on their first day

28. MET-80 DESIGN PHILOSOPHY
It would be CEMS-like

29. MET-80 DESIGN PHILOSOPHY
It would be CEMS-like
Integratable, rack-mounted,
industry-standard components and
quality manufacturing

30. We succeeded

31. The first compliance-reporting
sorbent trap mercury
monitoring systems in the U.S.
were at Dominion’s Salem
Harbor Power Station.
And they were…

32. The first compliance-reporting
sorbent trap mercury
monitoring systems in the U.S.
were at Dominion’s Salem
Harbor Power Station.
And they were…
Three MET-80s, Fully integrated, certified, and
reporting for the Massachusetts Mercury Rule

33. The industry took note…

34. NESCAUM
Technology Review,
2010

35. Section 2.8
Salem Harbor installation used as
benchmark for data availability using
Sorbent Trap Monitoring

36. Section 2.8

37. MET-80 Design Firsts

38. Patented Quick-Change Probe
Quick-change
traps and
integrated
sample lines

39. Integrated Cabinet Design
Front Rear

40. NEMA 4X Platform Installations

41. Shelter-Based Installations

42. High-Precision Mass Flow Meters

43. In-Situ Meter Calibration Audits

44. MATS-Tailored Software

45. We installed 33 systems prior to
the vacatur of CAMR in 2008

46. We installed another 10
systems post-CAMR for
state permitting
purposes

47. In total, prior to MATS,
CleanAir installed over 40
MET-80s for the utilities

48. 35 of these systems are
still in operation today

49. 7 years and counting for
the oldest
Footprint Power Salem Harbor

50. 2008-2010 Mercury Results
It all adds up to a lot
of operating experience!

51. And we’ve had a lot to SAY
about sorbent trap monitoring
over the years…

52. EUEC US EPA and TCEQ
2007
A&WMA
AQVI
McIlvaine Hot Topic

53. EUEC McIlvaine Hot Topic
A&WMA
2008

54. EUEC Source Evaluation Society
AQVII
2009

55. 2010

56. 2011 Power Plant Chemistry Magazine
AQVIII

57. AIChE National 2012
Reinhold APC/PCUG
WPCA

58. 2013 Edinburg ICMGP
EnviroTech Online

59. And we’ve collected and
published a lot of data…

61. A LOT of Data

62. And we have a long history of
operational and design
improvements of the MET-80
The MATS design is our 4th Generation

63. The word is out…

64. So far this year, 40 MET-80s have
been purchased for MATS

65. Why MET-80?

66. Three good reasons…

67. 1) Experience
No other sorbent trap system has
the installed base and operating
hours than the MET-80

68. 1) Experience
No other sorbent trap system has
the installed base and operating
hours than the MET-80
Literally millions of operating
hours…no one comes close

69. 1) Experience
No other sorbent trap system has
the installed base and operating
hours than the MET-80
Literally millions of operating
hours…no one comes close
NO ONE

70. 2) Reliability
No other sorbent trap system has
the documented reliability that the
MET-80 has.

71. 2) Reliability
No other sorbent trap system has
the documented reliability that the
MET-80 has.
We guarantee
data availability
of at least 95%.

72. 3) Support
No other sorbent trap system supplier
has the knowledge and depth of
resources that CleanAir offers.

73. 3) Support
No other sorbent trap system supplier
has the knowledge and depth of
resources that CleanAir offers.
Four service centers

74. 3) Support
No other sorbent trap system supplier
has the knowledge and depth of
resources that CleanAir offers.
Four service centers
A dozen dedicated
field engineers

75. 3) Support
No other sorbent trap system supplier
has the knowledge and depth of
resources that CleanAir offers.
As well as RATA
testing and regulatory
consulting capabilities

76. Contact CleanAir today to set up a personal consultation.
800-991-3300
contact@cleanair.com
Thanks!