Product Ihformation Mipa P35 elastic for plastic parts.

1. Mipa P 35 Elastic gb 3/0108
page 1 / 1
Product-Information
Mipa P 35 Elastic is an elastic contour putty especially developped for use to coatable plastic
parts. Excellent adhesivity , high elasticity, fast dry and easy to sand.
Colour shade heavy grey (approx. RAL 7024)
Mixing ratio 100 : 2
Hardener Mipa Härter P
Thinners
Spraying viscosity 20° C
Application spraying pressure spraying nozzle spraying operations
Air / Flowjar - Spray gun
Airless / Airmix
Pot life 4 - 5 min.
Coat thickness / dry film
Curing time / Flash off time
Dry Recoat time dust dry set to touch full hardness
Object Temp. 20° C The surface could be sanded afte r approx. 20 - 30 min.
Recommandations:
The substrate has to be clean, dry and free of grease. Abrade the surface. Remove all traces
of old coats, which are not in good condition and firmly adhering. Do not apply on thermoplastic
or acid containing ground coats (Reaktionsprimer). Mix well Mipa P 35 Elastic with hardener
Mipa Härter P. Apply within appropriate temperature range (not less than + 10 ° object
C
temperature).
Marking VbF Hazardous materials ordinance
Mipa P 35 Elastic n/a inflammable, Xn harmful, contains styrene
Mipa Härter P n/a Xi irritating, oxidizing, contains benzoyl-peroxid
All products should be disposed of in relation to the regulations of the environmental health
authorities. Protect your environment!
This data sheet is for information purpose only. To our knowledge the data provided complies with the latest standard and is based
on years of experience in the manufacture of our products. However the data is not binding and without warranty.
MIPA AG · D-84051 Essenbach · Tel. 08703/922-0 · Telefax