1. Why the turn signal quit working
To switches, lights don't light. May be the power supply, the following flash appliance to turn the
switch wire breaking out of place, or flash KESS V2 OBD2 Manager Tuning Kit relay and the
switch is faulty.
Check the steps:
(1) check the flash relay if there is a electric wire head.
(2) if there is electricity, and then use a screwdriver will flash relay two column short answer,
make it out, if then turned to the light, that is flashing relay is defective. Open the mpps v13.02
flash relay cover, check whether the coil, resistance is in good condition, if the resistance heating,
and contact cannot be closed, can press the activity contact, then if turned to the light, that flash
relay is defective. If the contact gap is too big, should be adjusted properly. If press activities of
contact, contact closure when the turn signal is not bright, can be used with a screwdriver will
contact short sub, if at this point the light shows a contact oxidation.
(3) use a screwdriver will flash relay two pick column short it if the lights AD900 are not bright,
could be turned to the switch is faulty. Inspection, respectively on wire to switch is available with
a screwdriver and a line left and right column. If the light is said to switch is faulty, should remove
the repair or replacement.
V124 Renault CAN Clip Diagnostic Interface Newest version B- Insatall video
http://www.youtube.com/watch?v=eV2Alkkf3jA&feature=youtu.be