3. Client: Project:
Cort Furniture / Tampa, FL Smooth Stucco Exterior Sidewalls
The sidewalls were very chalky and required the use of ASTEC #4200 Surface Conditioner.
Spider cracks were routed out and filled in with ASTEC Crack Patch, then skimmed over with
ASTEC WPM #9. The protective finish coat used was ASTEC #900 Ceramic Acrylic Coating in
a medium beige color.
The company sign pole had to be mechanically wire brushed to remove all scaling rust, then
primed with ASTEC B-16-71 Metal Primer and finish coated with ASTEC #900 in a dark grey
color.
Project completed: January 1996
Page ill-2
4. Client:
Dittler Brothers Printing Co.
Oakwood, GA
Lottery & Game Printers
Dealer:
Thermal Control Coatings, Inc.
Project:
12,932 sq. ft. Tilt Up Concrete
Exterior Sidewalls
A 15 degree reduction in inside temperature was realized after applying ASTEC #900 Ceramic
Coating.
Heat gain in the afternoons was negatively
impacting efficiency in the equipment operation as
well as employee comfort levels. After the
application of ASTEC, the plant needed less
energy in order to maintain comfortable air
,.' conditioning settings.
Project completed: May 1996
Page 1lI-3
5. Client:
Red Cross Life Guard Station
Jacksonville Beach, FL
Dealer:
Ospan, Inc.
Project:
Exterior Stucco Sidewalls
coated with ASTEC #100
Ceramic Finish Coat
Oceanfront Location / Salt
and Sand Abrasion / High
UV
,
Project completed: 1987
Page IIl-4
7. Client: Dealer:
General Services Offices Isothenn, Inc.
Quebec, Canada
Project:
80,000 sq. ft. Exterior Sidewalls
14 Story Pre-cast Concrete ASTEC #100 Ceramic Coating
Page ill-6
8. Client: Dealer:
Commodore Condominiums Duratek, Inc.
Honolulu, HI Dynamics, Inc.
Project completed: 1995
Page I11-7
9. Dealer: Project
WeatherShield Coatings, Inc. ASTEC Texture Sidewalls
Orlando, FL ASTEC 5000HB TEX coarse grade 4 to I grey
Page ID-8
10. Client:
Regency Towers
Myrtle Beach, SC
Project:
Stucco Exterior Sidewalls
Oceanfront I salt and sand abrasion
Water migration I mold and mildew
ASTEC WPM #8 waterproof membrane was
applied at the rate of two coats
ASTEC # I00 Ceramic finish coat was applied at
the rate of two
coats
This building has
held watertight for
over ten years,
including
weathering
Hurricane "'Hugo"
•
,
_.
I ...
.
•
i• • •
•
•
Page I1I-9
11. Client: Dealer:
Sub Zero Freezer Corporation rCB Corporation
Phoenix, AZ
Project completed: 1995
)'),000 Sq' ASTEC CERJ."f!C C(>..TING :1900 :u::p.:..na EXTERIOR CE~fE~T UALLS~
Page ill-l0
12. FIRST FEDERAL SAVINGS & LOAN
OF CITRUS COUNTY
SIDEWALLS
Coated 1988. Photo 1991.
ASTEC# 100
Smooth stucco
finish
CORPORATE CENTER
SIDEWALLS
Atlanta, GA
Metal mansart
caps and smooth
stucco finish
ASTEC #100
Page ill-II
13. ST. AUGUSTINE HISTORICAL SOCIETY
ST. AUGUSTINE, FLORIDA
Dealer: OSPAN, INC.
Sot ll~--.tlnl"· JI'''.h1rlC'•• ! ~lII:h
R>.~""'dl"ch l.illr.ln
CEMENT BLOCK SIDEWALLS
WPM #9 waterproof, ASTEC # I00 topcoat
Page ill-12
14. FIRST PRESBYTERIAN CHURCH
SIDEWALL
Coated 1986. Photo) 991.
HISTORICAL KEY WEST
Dealer: BUTCH BLAST
Page ill-I 3
15. Client: Kimberly-Clark Corporation Dealer: Protective Coatings of Texas, Inc.
San Antonio, TX
Project: 59,000 sq ft Tilt Up Concrete Sidewalls and Tanks
Project completed: February 1997
This project required enormous preparation: asbestos abatement, crack repairs, and expansion
joint replacement of all compounds. Two coats of ASTEC WPM #9 waterproof membrane and
two coats of ASTEC #900 ceramic acrylic finish coat were applied to the exterior sidewalls.
ASTEC 5000HB TEX coarse grade was applied on the lower walls of the loading docks. ASTEC
8-16-71 metal primer was used to prime all exposed structural steel and flashings.
Page ill-14